Finishedto the line.
Steel stud framing, boarding, taping and Level 5 finishing for homes and commercial interiors across the Okanagan. Curved bulkheads, shadow-line walls and LED reveals built right into the board.
Feature work leaves nowhere for a bad joint to hide. LED light rakes across every surface and finds every flaw, so we frame square, board tight and finish until the wall disappears behind the light.
Services
One crew, framing to final coatFraming
Steel and wood stud walls, partitions, soffits and bulkhead frames. Square, plumb, with backing set before it's covered.
Boarding
The right board for every room: moisture-resistant in wet areas, fire-rated at separations, sound board between units.
Taping & finishing
Tape, corner bead and multiple coats, sanded and checked under a work light at low angles before paint.
Bulkheads & curves
Rounded bulkhead corners, coves and drops built clean on steel framing, like the café work on this page.
LED reveals & feature walls
Recessed light channels and shadow-line panel walls, planned with your electrician and finished crisp.
Ceilings, repairs & paint
Texture removal, flat ceilings, water damage and after-trade patches, primed and painted to finish.
Before & after
Same wall · drag to compare
Watch a feature wall come together.
Set-out & frame
Lines snapped, steel track and studs set, wiring roughed in for the LED channel.
Board
Sheets hung to keep joints off the feature edges, screwed off on a tight pattern.
Tape & bead
Seams taped, reveal trim and corner bead set dead straight.
Finish
Coats built up and skimmed to Level 5, then sanded flat.
Paint & light
Feature colour rolled on and the cove LEDs switched on for walkthrough.
The real one · panel feature wall, Level 5
Bare wall
0%
Finish levels
Every quote names the levelNo finishing
Board hung only. Temporary or undecided areas.
Tape set
Above ceilings, plenums and attics.
One coat
Garages, storage and walls getting tile.
Two coats
Under heavy texture or knockdown.
Three coats
Living spaces with flat or eggshell paint.
Full skim coat
Dark colours, gloss and raking LED or window light.
Recent work
Kelowna & the Okanagan
Homeowners
Basements, renovations, texture removal and repairs that blend in.
Builders & GCs
Board and tape crews that keep your schedule and leave sites ready for paint.
Commercial
Tenant improvements, retail and restaurant fit-outs, feature ceilings and rated assemblies.
Before you book
How much does drywall cost in Kelowna?
It depends on square footage, ceiling height, board type and finish level. A basement and a curved LED ceiling price very differently, so we quote after a free site visit, with every line explained.
How long does a job take?
Compound needs drying time between coats, so even one room takes a few days from board to sand. A full basement usually runs one to two weeks. You get a schedule up front.
Can you build LED reveals and curved bulkheads?
Yes. Recessed light channels, cove lighting, rounded bulkheads and shadow-line panel walls are a big part of our commercial work. We coordinate the channel layout with your electrician before framing.
Do you handle small repairs?
Yes. Holes, cracks, nail pops, water damage and patches after other trades, textured and feathered to disappear under paint.
What about the dust?
Work areas are sealed off, floors protected and the site cleaned at the end of each day.